Clicky

How to make a send in template

1. Place an 18-inch square of clear plastic wrap so that it covers the top
portion of the head.
2. After pressing the wrap close to the head, use tape to contour the head
shape. Beginning at the forehead, place transparent tape perimeters of
the pattern. The areas of baldness determine these outer perimeters.
After you have taped the boundaries, cover the inner portion of the plastic
wrap with overlapping piece of tape. Apply 3 layers of tape. The tape will
lock the plastic wrap into a permanent transparent tape template.
3. Using a permanent marker, draw pattern lines on the tape
template while it is still on your head. Though requirements vary from
person to person, some rules of thumb apply to most.
Front hair line should usually be established by placing 3 or 4 of your
fingers(depending of your age) about the brow line. Lines are drawn from
that point to form a pattern, which covers the bald area. Deeper
recessions look most natural.
4. After the entire outer perimeter of the pattern is drawn, the desired
style should be indicated.
If a part is desired, draw a line from a pivot point at back crown to the
front hair line. Placement of the pivot point should correspond to what can
be seen of your original growth.
After you have finished marking the tape template, add one more layer of
tape (now 4) to cover and seal in the markings. Since the average life of a
hair system is 12 to 18 months, good record keeping is advisable to keep
the hair piece current. Remove the tape template from your head and trim
the excess plastic wrap off.

You can also send us an old hairpiece with a hair style you like or a picture of your old hairpiece with measurements. We can duplicate your old system.

 


There are no products to list in this category.